Sparkle FSP150-50PL 150W Flex ATX W/RoHS&PFC Switching Power Supply
PS-SP150PR
Our Price
:
$ 46.99
List Price
:
$
56.99
In Stock
:
Specifications
fr Part Number: FSP150-50PL1R#Features: # 20pin main connector#RoHS Ready#Complied with Flex ATX standard#Active Power Factor Correction Meeting with EN61000-3-2#High efficiency and reliability#Remote On/Off function#Internal 12V DC ball bearing fan included#Noise Killer (Thermal fan speed control
Detailed Features
l> #20pin main connector #RoHS Ready #Complied with Flex ATX standard #Active Power Factor Correction Meeting with EN61000-3-2 #High efficiency and reliability #Remote On/Off function #Internal 12V DC ball bearing fan included #Noise Killer (Thermal fan speed control function) #Low noise and ripple #Complies with FCC part 15 subpart J Class B and CISPR 22 Class B #Output over voltage, short circuit, and over current protection #100% Hi-pot, ATE, and burn-in tested #Re-settable power shut down #Approved by UL 1950, CSA C22.2 Level 3, TUV EN60950, NEMKO (CB Report), CE #Input:
#Input Range: 90~265V AC, Full Range Input #Frequency: 47~63Hz #Input Current: 4A (RMS) @ 115V AC, 2A (RMS) @230V AC #Inrush Current: 50A Max for 115V AC, 80A Max for 230V AC Cold start
#Output:
#Total Watts: 150 W #+5V and +3.3V total output not exceed 85W #+12V, +3.3V, +5V, and +12V will have the regulation ±10% when all load take off
#Dielectric Withstand: Input to frame ground 1800V AC for 1 second #Efficiency: 68% at minimum measured at nominal AC main voltage and frequency with maximum load on all output #Rise Time: Less than 20ms #Hold-up Time: 17ms minimum at nominal input voltage #Power Good Signal: Power on delay time 100 ms to 500 ms, off delay 1ms minimum (TTL and CMOS compatible) #Leakage Current: Not exceed 0.75mA at 115V AC, 60Hz #MTBF: 100,000 hours on maximum load at +25°C #Dimension (WxLxH): 3.2 x 6 x 1.6 inch / 81.5 x 150 x 40.5 mm
Your opinion is important to us.If
you have spotted a typo, discovered an incorrect price, or encountered a
technical issue on this page, we want to hear about it. Thanks again for your
feedback
